Deutz 1012 Spezifikationen PDF herunterladen (Seite 157)

100

101

Service Training

Section 4.4

Page 13

4.4.4.5 STEERING STOP ADJUSTMENT

1 Stop screw

2 Locknut

3 Axle body

4 Steering cylinder

To prevent damage to the hydraulic cylinder, check and adjust, if necessary, the left and right-hand steering

stop after repairing a steering knuckle, track rod or steering cylinder.

- Loosen the locknut (2) and screw out the M12x60 stop screw (1) approximately 10 turns.

- Start the engine and turn the steering wheel until the hydraulic cylinder is fully extended.

- Screw in the stop screw until it contacts the axle (3).

- Turn the steering wheel until the steering cylinder (4) is centred, screw in the stop screw (1) 2 to 3 turns

and lock it with the nut (2).

NOTE: Adjust the steering stop on the other side as described above.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 281 282

Service Training 1
353 804 2401.0906 282

Kommentare zu diesen Handbüchern

Keine Kommentare

Deutz 1012 Spezifikationen Seite 157

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Deutz 1012