Deutz 914 Technical Information PDF herunterladen (Seite 63)

● Undo hex nut 1, remove V-belt pulley half

2, V-belt 3 and inner washer kit 7.

● Remove inner washers 4, posterior V-belt

3, inner washer kit 6 and pulley half 5.

● To retension, remove one or more inner

washers from kits 6 and 7. Place removed

washers in front of or behind pulley half 2

to ensure belt alignments. Always remove

only the same number of washers from

each kit.

● For installation, now proceed in the re-

verse order. Whilst tightening the nut 1, turn

engine over simultaneously in order to

prevent crushing the V-belt.

Check and change belts only with the engine

off.

Reinstall V-belt guard, if necessary. Retension

V-belt after it has ran for 15 minutes.

If one belt locks or is damaged, always

replace both belts. The difference of length

between the new belts may not exceed

0.15%.

6.5.7 Air compressor model with

dual belts

6.5 Belt Drives Service and Maintenance

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 84 85

Keine Kommentare

Deutz 914 Technical Information Seite 63